Modify the control limits for EWMA Chart

In These multiples of the standard deviation, enter one or more values to display additional standard deviation lines on your control chart.

For example, you can display additional limits at ±1 and ±2 standard deviations. Values that you enter affect only the line position on the control chart, not the test results.

Default 3 sigma limits

Additional sigma limits at 1 and 2 standard deviations

You can specify a lower bound and an upper bound for the control limits. If the calculated control limit is farther from the center line than the value that you specify, Minitab displays the bound instead of the control limit. Minitab labels the lower bound as LB and the upper bound as UB.

By default, Minitab calculates the control limits using the actual subgroup sizes. In the EWMA chart, even with constant subgroups sizes, the control limits steadily converge after more and more points are plotted. When the subgroup sizes differ, you can make the convergence look smoother by assuming a constant subgroup size. Under When subgroup sizes are unequal, calculate control limits, select Assuming all subgroups have size, and enter a subgroup size.

This option is especially useful when all subgroups were intended to be the same size, but some subgroups are a different size. For example, some subgroups are smaller because of missed measurements. In that case, set the subgroup size to the intended size.

For example, the data for the following charts is the same, but the control limits for the second chart were calculated based on a fixed subgroup size.

Actual subgroup sizes

Fixed subgroup size