The Laney U' chart is similar to a traditional U chart. Both charts monitor the number of defects per unit that are produced by your process. However, if your data exhibit overdispersion or underdispersion, a Laney U' chart may more accurately distinguish between common-cause variation and special-cause variation.
Overdispersion can cause a traditional U chart to show an increased number of points outside the control limits. Underdispersion can cause a traditional U chart to show too few points outside of the control limits. The Laney U' chart adjusts for these conditions. For more information, go to Overdispersion and underdispersion.
Red points indicate subgroups that fail at least one of the tests for special causes and are not in control. If the same point fails multiple tests, then the point is labeled with the lowest test number to avoid cluttering the graph. If the chart shows out-of-control points, investigate those points. For more information, go to Specify subgroups to estimate parameters for Laney U' Chart.
Consider the following example of a Laney U' chart. The Sigma Z value (approximately 5.5) is greater than 1, which indicates that the control limits on the Laney U' chart are wider than those on a traditional U chart to adjust for overdispersion. The defect rate for subgroup 23 is out of control. When you hold the pointer over a red point, you can get more information about the subgroup. You should identify any special causes that may contribute to the unusually high rate of defects for that subgroup.