Interpret the key results for a T² Chart

Complete the following steps to interpret a T2 chart. Key output includes the T2 chart and test results.

Step 1: Determine whether the process location is in control

The T2 chart plots the T2 for each subgroup to measure whether the process locations of several related variables are simultaneously in control. The center line is the median of the theoretical distribution of T2 statistics. The upper control limit is based on the number of samples, the size of each sample, and the number of variables.

Red points indicate subgroups that are above the upper control limit and not in control. One disadvantage to multivariate charts is that the scale is unrelated to the scale of any of the variables, and out-of-control signals do not reveal which variable (or combination of variables) caused the signal.

In these results, three points are out of control. Subgroups 2, 18, and 19 are above the upper control limit, which indicates that special causes may currently affect the process. When you hold the pointer over a red point, you can get more information about this subgroup.

Step 2: Identify which points failed the test

Investigate any subgroups that are above the upper control limit. The Session window output shows which points are above the upper control limit, as shown here.

Test Results for T² Chart of Stay, Satisfaction Point Variable P-Value Greater Than UCL 2 Stay 0.0030 Satisfaction 0.0067 18 Stay 0.0010 Satisfaction 0.0002 19 Satisfaction 0.0000 * WARNING * If graph is updated with new data, the results above may no longer be correct.
By using this site you agree to the use of cookies for analytics and personalized content.  Read our policy