Overview for NP Chart

Use NP Chart to monitor the number of defective items where each item can be classified into one of two categories, such as pass or fail. Use this control chart to monitor process stability over time so that you can identify and correct instabilities in a process.

For example, a delivery service manager uses an NP chart to monitor the number of delivery vehicles that are out of service each day for 2 months. A vehicle that is out of service is considered a defective unit.

The chart shows that, on average, 25 of the delivery vehicles are out of service each day. The number of defective units for day 19 is out of control. The manager should identify any special causes that contribute to the unusually high number of defectives.

Where to find this control chart

To create an NP chart, choose Stat > Control Charts > Attributes Charts > NP.

When to use an alternate control chart

  • If you can count the number of defects on each item, use U Chart, Laney U' Chart, or C Chart to plot the number of defects per unit.
  • If your subgroup sizes are not equal and you want the center line to be straight, use P Chart or Laney P' Chart to plot the proportion of defective items.

  • If your data exhibit overdispersion or underdispersion, Laney P' Chart may more accurately distinguish between common-cause variation and special-cause variation. Overdispersion can cause an NP chart to show an increased number of points outside the control limits. Underdispersion can cause an NP chart to show too few points outside of the control limits. The Laney P' chart adjusts for these conditions. You can test your data for overdispersion and underdispersion with P Chart Diagnostic. For more information, go to Overdispersion and underdispersion.
By using this site you agree to the use of cookies for analytics and personalized content.  Read our policy