How to arrange Taguchi response data in the worksheet

In a usual Taguchi robust parameter design experiment, you would subject each control factor combination to each of the noise conditions and measure the response variable. If you are doing a dynamic experiment, the response is measured at each level of the signal factor. Record the results for each noise condition in a separate response column in the worksheet.

Columns A–E (the control factors) and Pressure (the signal factor) are columns of the orthogonal array design. Noise1 and Noise2 are the response data that were measured at each noise condition.
A B C D E Pressure Noise1 Noise2
1 1 1 1 1 20 37 48
1 1 1 1 1 40 71 93
1 1 2 2 2 20 29 44
1 1 2 2 2 40 51 86
2 2 1 1 2 20 19 30
2 2 1 1 2 40 39 57
2 2 2 2 1 20 33 39
2 2 2 2 1 40 62 76
1 2 1 2 1 20 25 33
1 2 1 2 1 40 51 60
1 2 2 1 2 20 44 60
1 2 2 1 2 40 79 109
2 1 1 2 2 20 31 44
2 1 1 2 2 40 66 82
2 1 2 1 1 20 22 32
2 1 2 1 1 40 47 65
By using this site you agree to the use of cookies for analytics and personalized content.  Read our policy