# Interpret the key results for I-MR Chart

Complete the following steps to interpret an I-MR chart. Key output includes the Individuals chart, MR chart, and test results.

## Step 1: Determine whether the process variation is in control

Before you interpret the individual chart (I chart), examine the moving range chart (MR chart) to determine whether the process variation is in control. If the MR chart is not in control, then the control limits on the I chart are not accurate.

The moving range chart plots the moving ranges. The center line is the average of all moving ranges. The control limits on the moving range chart, which are set at a distance of 3 standard deviations above and below the center line, show the amount of variation that is expected in the moving ranges of the standardized data..

Red points indicate observations that fail at least one of the tests for special causes and are not in control. If the same point fails multiple tests, then the point is labeled with the lowest test number to avoid cluttering the graph. If the chart shows out-of-control points, investigate those points.

Out-of-control points can influence the estimates of process parameters and prevent control limits from truly representing your process. If out-of-control points are due to special causes, then consider omitting these points from the calculations.

## Step 2: Determine whether the process mean is in control

The individuals chart (I chart) plots individual observations. The center line is an estimate of the process average. The control limits on the I chart, which are set at a distance of 3 standard deviations above and below the center line, show the amount of variation that is expected in the individual sample values.

Red points indicate observations that fail at least one of the tests for special causes and are not in control. If the same point fails multiple tests, then the point is labeled with the lowest test number to avoid cluttering the graph. If the chart shows out-of-control points, investigate those points.

Out-of-control points can influence the estimates of process parameters and prevent control limits from truly representing your process. If out-of-control points are due to special causes, then consider omitting these points from the calculations.

## Step 3: Identify which points failed each test

Investigate any subgroups that fail the tests for special causes. By default, Minitab conducts only Test 1, which detects points that fall outside of the control limits. However, if you conduct additional tests, then points can fail multiple tests. The table shows exactly which points failed each test, as shown here.

 Tests for Special Causes
 Results for I Chart
 Test Description Failed Observations 1 1 point > 3 standard deviations from the center line None
 Results for Moving Range Chart
 Test Description Failed Observations 1 1 point > 3 standard deviations from the center line None
###### Note

When you use several tests at the same time, the sensitivity of the chart increases. However, the false alarm rate also increases, which can make you react to the test results unnecessarily.

For more information on each of the tests and when to use them, go to Using tests for special causes in control charts.

By using this site you agree to the use of cookies for analytics and personalized content.  Read our policy